Fison Potentiostat FM-PT-A100 controls potential across ±10 V and current up to ±2 A, with current ranges from 2 nA to 2 A and a current sensitivity of 1 pA. As electrochemical testing equipment, it supports 2-, 3- or 4-electrode systems, with a potential resolution of 10 μV and a rise time below 1 μs for currents under 10 mA. The potentiostat holds and measures electrode potential and current in electrochemical cells.
| Electrode system | 2-, 3- or 4-electrode |
| Potential control range | ±10 V |
| Current control range | ±2 A |
| Maximum current output | 2 A |
| Current ranges | 2 nA to 2 A, 10 ranges, automatic range selection |
| Compliance voltage | ±21 V |
| Potential control accuracy | 0.1% × full range ± 1 mV |
| Current control accuracy | 0.1% × full range |
| Potential resolution | 10 μV (>100 Hz), 3 μV (<10 Hz) |
| Current sensitivity | 1 pA |
| Rise time | < 1 μs (< 10 mA), < 10 μs (< 2 A) |
| Reference electrode input impedance | 10¹² Ω || 20 pF |
| CV and LSV scan rate | 0.001 mV to 10,000 V/s |
| CA and CC pulse width | 0.0001 to 65,000 s |
| Potential increment during scan | 0.076 mV @ 1 V/ms |
| Current increment during scan | 1 mA @ 1 A/ms |
| Minimum potential increment in CV | 0.075 mV |
| AD data acquisition | 16-bit @ 1 MHz, 20-bit @ 1 kHz |
| DA resolution | 16-bit, setup time 1 μs |
| Low-pass filters | Covering 8 decades |
| Interface | USB |
| Dimensions (W × D × H) | 365 × 305 × 160 mm |
| Weight | 6.5 kg |
Potentiostat FM-PT-A100 is used in electrochemistry, corrosion testing, battery research, materials science, sensor development, and energy storage laboratories to analyze electrochemical properties, evaluate electrode reactions, and study material performance.
| Instrument host | 1 |
| CS studio software | 1 |
| Power cable | 1 |
| USB cable | 1 |
| electrode cable | 1 |
| Dummy cell | 1 |
| Manual | 1 |
| Ag/AgCl reference electrode | 1 |
| Glassy carbon working electrode (3mm) | 1 |
| Pt wire counter electrode | 1 |
| electrochemical cell 250 ml (non-sealed) | 1 |
